Licensed Drywall Contractor in Brampton, Ontario

Yes. Legal-suite basement finishing is the highest-volume service we provide in Brampton. Ontario Building Code Part 9 requires a 5/8-inch Type X fire separation at all stairwell and garage locations, moisture-resistant Green Board in the suite bathroom, and egress window sizing in any room used as a sleeping area. We coordinate with the City of Brampton building permit inspection sequence.

Ontario Building Code Part 9 requires a minimum 30-minute fire separation between an attached garage and the house interior. This is typically achieved with one layer of 5/8-inch Type X gypsum panel on the house side of the wall. Where the garage is below a bedroom or habitable space, a 1-hour assembly (Type X on both sides of the wall) is required. We confirm the required assembly against your permit drawings during the estimate.

Yes, for all pre-1980 Brampton homes. Bramalea and older Brampton neighbourhoods have a meaningful rate of positive asbestos results in acoustic spray texture applied before 1980. We coordinate certified air or bulk sampling and route to a licensed abatement contractor where required before our scope starts.

We schedule the framing inspection before panels go up, because the fire-separation configuration and stud layout must be visible to the building official. After passing the framing inspection, we mobilise the hang crew to minimise time between approval and drywall. For larger projects, we confirm the inspection timeline with the City of Brampton during permit application.

Our 2026 rate for drywall installation in Brampton is $2.50 to $5.00 per square foot installed and finished, covering the panels, hanging, taping, three compound coats, and dustless sanding. Type X or moisture-resistant panel upgrades add $0.50 to $1.50 per square foot, and Level 5 finishes on custom homes sit at the top of the range. Every quote follows a free on-site estimate with line-item pricing.

As of 2026, basement drywall in Brampton runs $2.50 to $5.00 per square foot installed and finished. A typical Brampton basement (700 to 1,000 sq ft) runs $4,500 to $14,000 for full drywall including steel-stud framing, vapour barrier, and moisture-resistant panels. Legal-suite projects with a bathroom and Type X fire separation run toward the higher end of that range.

Yes. Addition drywall is a common occupied-home project in Brampton. We seal the work area from the main house with temporary hoarding or plastic at the connection point, use HEPA-filtered sanding to minimise dust spread, and schedule dusty work phases for times when the impact on the family is lowest.

A single-room drywall install in a Brampton detached home runs 3 to 7 working days from framing through Level 4 finish: hanging takes 1 to 2 days, and taping and mudding take another 3 to 5 days because each compound coat must dry before the next. A full basement finish runs 10 to 18 working days. A rear addition or second-storey drywall package runs 2 to 5 weeks depending on square footage and ceiling configuration.

Ask for proof of WSIB coverage and liability insurance, a written line-item estimate, and photos of finished projects similar to yours. For legal-suite or addition work, confirm the contractor knows the Ontario Building Code fire-separation requirements and will sequence drywall around City of Brampton inspections. Toronto Drywall Pro has operated since 2002, carries $2M liability insurance with documented WSIB coverage, and provides free on-site estimates.

Yes. We cover all of Brampton including newer north Brampton communities like Sandalwood Parkway, Vales of Castlemore, Gore Road corridor, and the Highway 427 extension area. Most north Brampton jobs get same-week scheduling.